Emergency and roadside Mobile truck repair
Need the truck fixed where it is parked?
Mobile truck repair brings the technician to the unit at your yard, a job site, a customer lot or wherever it is parked off the highway. It suits a truck that will not start or move, one that should not be driven, or a fleet that wants repairs done where units sit to cut downtime. Stopped on the highway instead? That is roadside repair; otherwise, send the unit, the location and the fault, and we will say whether it can be done on site.
Should I drive it to a shop or have it repaired where it is?
If there is any doubt about the brakes, steering or wheels, or a warning is telling you to stop, leave it where it is. Driving a unit with that kind of fault turns a parked repair into a highway breakdown, or worse. If it is safe to drive and the job needs a hoist or a long stay, a shop visit can make more sense; ask and we will say which.
Example: a service unit set up beside a parked truck, beacons on and the work light up; the repair happens where the unit sits, when it can be done safely there.
Call the nearest location.
Call now (204) 960-5390Injury, fire or danger: call 911 first. We take calls 24/7.
- Winnipeg (204) 960-5390
- Brandon (431) 279-4008
Problems we commonly inspect
- Will not start in the yard
- A unit that has been sitting: batteries, cables, the starter or a fuel problem.
- Found at the pre-trip and should not go out
- A brake, air, steering or wheel-end problem caught before the unit leaves the yard.
- Broke down at a job site or customer lot
- A gravel pit, a construction site, a farm yard or a delivery: off the highway but going nowhere.
- A write-up holding up dispatch
- A lamp, a small air leak or a mud flap that keeps a unit parked until it is fixed.
- Several units need work
- Repairs done where the fleet is parked, so drivers are not shuttling trucks back and forth.
- A trailer dropped somewhere awkward
- A trailer with a brake, lamp or air problem left at a dock or a drop yard.
Stop driving, or can it wait?
Stop and get help
- Brakes, air pressure or steering are not normal: leave it parked.
- A fluid leaks steadily or onto a hot part.
- A dash message says to stop the engine, or the truck is in a severe derate.
- The unit is on soft ground, ice or a slope where moving it could make things worse.
May be safe to assess further
- The fault is a lamp, a non-critical warning or a cosmetic item and the truck drives normally.
- The unit needs routine work and can be moved within the yard safely.
Continuing to operate may risk further damage or create a safety issue. When in doubt, stop where it is safe and call. Injury, fire or immediate danger: call 911 first.
What to do right now
- If moving the unit is not safe, leave it where it is and tell us exactly where it sits.
- Make room around it if you can: other units, freight or equipment parked tight against it.
- Arrange gate access, a contact on site, and tell us any site rules such as protective equipment, sign-in or an escort.
- Send photos of the fault, the dash and the ground around the unit.
What not to do
- Do not drive a unit that should not be driven just to make it easier to reach.
- Do not start taking parts off ahead of the technician.
- Do not book a mobile repair for a truck stopped on a highway shoulder; that is a roadside call.
- Do not leave the unit locked with no keys and no one on site.
When you call, have ready
- The unit: make, model, year, unit number, and the VIN if parts may be needed.
- Address or map pin, which gate or entrance to use, and who will meet the technician.
- The fault in plain words, when it started, and any codes on the dash.
- Photos of the problem, the dash, and the space around the unit.
- Site rules: when the site is open, protective equipment, sign-in or escort.
- Whether the keys are with the unit and whether it can be started.
Not sure exactly where you are?
Your phone can find the spot and write the text for you.
Your text
Uses this phone’s location. Nothing is sent: copy it to paste in a message or read it out when you call.
What we check
Depending on the symptoms, the technician may check:
- The fault the driver or yard reported, confirmed at the unit
- Batteries, cables, the starter and charging on a unit that will not start
- Fault codes and the conditions that set them
- Brake and air components that can be reached safely without lifting the unit
- Lamps, wiring and connectors on the truck and trailer
- Belts, hoses and fluid leaks
- Tires and wheel ends
- Whether the unit is safe to move once the repair is done
Common causes
Possibilities, not a diagnosis of your unit:
- Batteries run down by parasitic draw on a unit that has stood for days
- Corroded cables or connectors after cold, wet weather
- Fuel gelling or a blocked filter on a unit left out in the cold
- Damage from tight yard manoeuvring: a crushed line, a cord or a lamp
- Wear that was noted at an earlier service and not yet repaired
Roadside or shop?
Often done where the unit is
- Batteries, starters and charging faults
- Lamps, wiring and connectors
- Air lines, hoses, belts and many sensors
- Diagnosis to decide what the unit needs and whether it can be moved
Often better handled in a shop
- Jobs that need the unit raised on a hoist
- Long repairs, or ones that need a clean, controlled space
- Major engine, transmission or clutch work
Every fault and every spot is different. Describe it on the call and we will tell you what can be done where the unit is.
How it works
Send the details
Unit, location, gate access and the fault, with photos. This decides whether the job suits a mobile repair and what parts to bring.
Check the site
A workable spot is firm and level, has room for a service truck alongside, is away from moving traffic and yard equipment, and lets the unit be secured so it cannot roll.
Repair on site
The technician diagnoses at the unit and repairs what can be done safely there.
If it cannot be finished there
When the job needs a hoist, a controlled space or parts not on hand, you get the reason and the options so you can plan around the unit.
Where we work: Winnipeg, Highway 1 and Brandon
Mobile repair covers units parked at yards, job sites and lots around Brandon, Headingley, Winnipeg and the surrounding Manitoba area. A truck stopped on or beside the Trans-Canada Highway (Highway 1) is a roadside job instead, because traffic changes what can safely be done.
Roadside assistance and mobile truck and trailer repair 24/7 along the Trans-Canada Highway (Highway 1) between Winnipeg and Brandon, in both directions: Headingley, St. François Xavier, Elie, Oakville, Portage la Prairie, MacGregor, Austin, Sidney, Carberry and Douglas, and the yards and roads around them.
- 646 Pipeline Road, Winnipeg, MB R2P 2T7 (204) 960-5390
- 1601 Moreland Ave, Brandon, MB R7C 1A6 (431) 279-4008
Questions
- What is the difference between mobile repair and roadside repair?
- Where the truck is and how urgent it is. Roadside repair is for a truck stopped on or beside the highway; mobile repair is for a unit parked off the road (a yard, a site, a lot) where the work can be planned and there is room to work.
- What can be repaired on site?
- Many common faults, if the site is workable. Batteries, starting and charging, lamps and wiring, air lines, hoses, belts and many sensors are often done where the unit stands. Work that needs a hoist or major parts out is often better handled in a shop.
- Does the truck need to be on level ground?
- Firm, level ground is much safer and is often needed. A unit on a slope, soft ground or ice may not be safe to jack or work around, so the job may have to wait or the unit be moved first, if it can be moved safely.
- Can you work on several units in our yard in one visit?
- Ask when you book. Send the unit list and what each one needs; grouping work where the fleet is parked is one of the main reasons to choose a mobile repair.