Emergency and roadside Truck no-start repair

Truck won't start?

Nexgen diagnoses commercial trucks that will not start: no crank, a click, a slow crank or a crank with no fire, flat batteries, starter faults and charging problems that ran the batteries down. Many no-starts can be traced and fixed where the truck sits, in a yard, at a fuel stop or on the shoulder, when it is safe to work there. Stop cranking, note exactly what the key does, and call.

Should I keep trying to start it?

No. Two or three short tries tell you what the truck is doing; more than that drains whatever charge is left, heats the starter and its cables, and makes the original fault harder to separate from damage done since. If the engine has not caught after a few attempts, stop, leave the key off and call with what you heard.

Corroded cable end at the battery bank Example

Example: cranking current leaves the battery bank through one cable; a corroded end or a tired battery is where a no-start is often found.

Call the nearest location.

Call now (204) 960-5390

Injury, fire or danger: call 911 first. We take calls 24/7.

Problems we commonly inspect

Nothing at all at the key
No crank, no click, and the dash may be dark: power is not reaching the cab, the batteries are flat, or a disconnect switch is off.
One click, or rapid clicking
One heavy click with a bright dash often points at the starter or its solenoid; a fast chatter usually means the batteries cannot hold the starter in.
Slow, laboured crank
The engine turns over but drags: a weak battery bank, a corroded cable end or a starter pulling too much current.
Cranks normally but will not fire
The starting side is doing its job. The engine is short of fuel, has air in the fuel system, or the engine controls are not letting it run.
Whirr or grind with no crank
The starter spins but does not engage the flywheel, or engages badly: a starter drive or ring-gear problem.
Died on the road and will not restart
If the battery light came on first, the truck was likely running on its batteries until they gave out: a charging fault, not a starting one.
Flat again after a jump or a charge
Something is draining the batteries while parked, a battery will no longer hold charge, or the alternator is not putting it back.

Stop driving, or can it wait?

Stop and get help

  • A hot-electrical or burning smell, smoke, or melted insulation at the batteries, starter or cables.
  • A battery case that is swollen, cracked, hissing, leaking, or smells of rotten eggs.
  • Sparks or arcing at the battery box when the key is turned.
  • A starter that keeps running after the key is released.
  • A grinding noise each time you try to crank.

May be safe to assess further

  • The dash lights normally and the engine cranks at full speed but will not fire: the fuel gauge and any warning lamps are worth noting before you call.
  • The truck started after a jump and the battery light is out: it may be moved to a safer place, but have the charging system checked before it is shut off far from help.

Continuing to operate may risk further damage or create a safety issue. When in doubt, stop where it is safe and call. Injury, fire or immediate danger: call 911 first.

What to do right now

  1. Stop cranking after a few short tries and leave the key off.
  2. Turn the key to the on position without cranking and note what lights up: full dash, a dim or flickering cluster, or nothing.
  3. Switch off headlights, heaters, inverters and anything else drawing on the batteries while you wait.
  4. If the truck is in or beside a live lane and has no power for its hazard lights, get yourself clear of the truck and traffic first.
  5. Call with what the key does and what the dash shows. If anyone is hurt, or there is smoke or fire, call 911 before anything else.

What not to do

  • Do not keep cranking in long bursts hoping it will catch.
  • Do not spray ether or starting fluid into the air intake.
  • Do not open the battery box or handle cables if a battery is hissing, smoking or smells of rotten eggs.
  • Do not strike the starter or bridge its terminals to make it turn.
  • Do not get under the truck to reach the starter or cables.

When you call, have ready

  • Where the truck is sitting: a yard or lot address, or the highway, direction of travel and the closest crossroad or km marker.
  • Exactly what the key does: no power, dash only, one click, rapid clicks, slow crank, normal crank with no start, or a grind.
  • Whether the dash and lights come on, and whether they dim or go out when you try to crank.
  • Whether a jump-start or a charger was tried, and what happened.
  • Whether a battery, charging or engine light was on before it quit, and any recent battery, starter or electrical work.
  • How long the truck has been sitting, whether it was plugged in, and whether anything was left switched on.

Not sure exactly where you are?

Your phone can find the spot and write the text for you.

Your position

Open in Maps

What a pin cannot say

Your text

Uses this phone’s location. Nothing is sent: copy it to paste in a message or read it out when you call.

What we check

Depending on the symptoms, the technician may check:

  • State of charge and a load test of each battery in the bank, not just the bank as a whole
  • Battery terminals, cable ends and ground straps for corrosion, looseness and heat marks
  • The main positive and ground cables between the batteries, starter, engine block and frame
  • The battery disconnect switch and any low-voltage disconnect
  • The starter motor, its solenoid and the starter relay or magnetic switch
  • The key switch and the neutral or clutch start-interlock circuit
  • Alternator output, its drive belt and the charging wiring back to the batteries
  • Parasitic draws that flatten the batteries while the truck is parked
  • Fuel level, filters and air in the fuel system when the engine cranks but will not run
  • Stored engine fault codes that may stop the engine from firing

Common causes

Possibilities, not a diagnosis of your unit:

  • Batteries run down by a light or accessory left on, a parasitic draw or a long sit
  • One battery at the end of its life dragging the rest of the bank down
  • Corroded, loose or heat-damaged terminals and cables
  • A failed starter motor or solenoid, or a worn starter drive
  • An alternator, regulator or belt fault that let the batteries drain while driving
  • A fault in the key switch, the starter relay or a start-interlock circuit
  • Running out of fuel, a plugged fuel filter or air drawn into the fuel lines
  • An engine control or security fault stopping the engine from firing

Roadside or shop?

Often done where the unit is

  • Battery testing and battery replacement
  • Cleaning or replacing terminals, cable ends and ground straps that can be reached safely
  • Many starter and alternator replacements, with the truck off the road on firm ground
  • Finding a parasitic draw
  • Re-priming the fuel system after a run-out

Often better handled in a shop

  • Engine faults found while diagnosing a crank-no-start
  • Cable runs or wiring that must be replaced deep under the cab or along the frame
  • Starter or alternator work on a truck stopped where it cannot be worked on safely

Every fault and every spot is different. Describe it on the call and we will tell you what can be done where the unit is.

How it works

  1. What the key does

    Your description of the click, the crank and the dash narrows the fault to batteries, cables, the starter or fuel before anyone arrives.

  2. Batteries and cables first

    The bank is tested battery by battery and the cables checked for voltage loss, because a starter cannot be judged on weak supply.

  3. Starter or fuel

    With good supply confirmed, the test moves to the starter circuit if it will not crank, or to fuel and engine controls if it cranks and will not fire.

  4. Charging check before leaving

    Once it runs, the alternator output is checked so the truck is not left to go flat again on the next leg.

Where we work: Winnipeg, Highway 1 and Brandon

A dead truck on the shoulder of the Trans-Canada Highway (Highway 1) near Brandon, Headingley or Winnipeg cannot run its hazard lights for long. Tell us early if the batteries are failing, which way you were travelling and the nearest crossroad.

Roadside assistance and mobile truck and trailer repair 24/7 along the Trans-Canada Highway (Highway 1) between Winnipeg and Brandon, in both directions: Headingley, St. François Xavier, Elie, Oakville, Portage la Prairie, MacGregor, Austin, Sidney, Carberry and Douglas, and the yards and roads around them.

Questions

Why does my truck click but not start?
Usually the starter is not getting enough current. A single heavy click with a bright dash often points at the starter solenoid or a poor cable connection; rapid clicking usually means the batteries are too low to hold the starter in. A battery and cable test tells the two apart.
My truck cranks but won't start. Is it the battery?
Usually not, if it cranks at normal speed. A normal crank means the batteries and starter are working; the engine is short of fuel, has air in the fuel system, or the engine controls are not letting it run. Note the fuel level and any warning lamps.
Is it the battery, the starter or the alternator?
What the key does is the first clue. No power or a fast chatter points at the batteries or cables; one heavy click with full dash power points at the starter; a truck that starts after a jump and dies again on the road points at charging. Testing confirms it.
Why does my truck keep going flat after a jump-start?
Something is draining the batteries or nothing is recharging them. A jump gets the engine running but does not fix the cause: a parasitic draw, a battery that no longer holds charge, or an alternator, belt or charging-wire fault.
Can a no-start be fixed at the roadside?
Often, yes. Batteries, cables and many starter and alternator replacements can be done where the truck sits, if it is safe to work there. Engine faults and wiring buried along the frame are often better handled in a shop.