Emergency and roadside Truck cooling and overheating repair
Truck overheating or losing coolant?
Nexgen diagnoses and repairs cooling-system problems on commercial trucks: overheating, coolant leaks, hoses and clamps, radiators, fans and fan clutches, thermostats, water pumps and belts. A split hose, a belt or a fan-clutch control fault can often be repaired where the truck stands once the engine has cooled, while a radiator or water pump job is often better handled in a shop. If the temperature keeps climbing, pull off the road safely, shut the engine down and call.
Can I keep driving if the temperature gauge is climbing?
No, not if it keeps climbing or a high-temperature or stop-engine warning comes on. Get off the travelled lane where it is safe and shut the engine down. Many engines will derate or shut themselves off to protect themselves, and driving through an overheat may risk a warped cylinder head, a failed head gasket or a seized engine. A gauge that rises on a long pull with a heavy load and settles once the load eases is a different situation: keep watching it and have the system checked soon.
Example: coolant circulating between the engine and the radiator; when the loop loses coolant or the fan stops helping, the temperature climbs.
Call the nearest location.
Call now (204) 960-5390Injury, fire or danger: call 911 first. We take calls 24/7.
- Winnipeg (204) 960-5390
- Brandon (431) 279-4008
Problems we commonly inspect
- Temperature climbs on grades or with a heavy load
- Normal on the flat, then rising on a long pull, into a headwind or in summer heat: a system with no margin left.
- Overheats at idle or in slow traffic
- Fine at highway speed but hot when ram air stops: often the fan or fan clutch not engaging.
- Steam or coolant under the front of the truck
- A puddle, spray or steam from the engine bay usually means a hose, clamp, radiator or water pump leak.
- Coolant level keeps dropping, no leak in sight
- Coolant may be leaving through the exhaust, the oil or a heater core instead of onto the ground.
- White exhaust smoke with a sweet smell
- Coolant burning in the engine or exhaust: possibly an EGR cooler or head gasket leak.
- Fan roars all the time, or never engages
- A fan clutch stuck on wastes fuel; one stuck off lets the engine overheat at low speed.
- No cab heat in winter
- Low coolant, air in the system or a thermostat problem, often noticed before the gauge shows anything.
Stop driving, or can it wait?
Stop and get help
- The temperature gauge keeps rising or is in the red zone.
- A high coolant temperature, low coolant or stop-engine warning comes on.
- Steam, a coolant spray or a burning smell from the engine bay.
- A belt has broken or you hear a loud squeal followed by the gauge rising.
- Thick white exhaust smoke together with a falling coolant level.
May be safe to assess further
- The gauge rose on a long climb and came back to normal on the flat.
- A small drip noticed with the truck parked and cold, with the level still in range.
- Weak cab heat with a normal temperature gauge.
Continuing to operate may risk further damage or create a safety issue. When in doubt, stop where it is safe and call. Injury, fire or immediate danger: call 911 first.
What to do right now
- Watch the temperature gauge. If it keeps climbing, ease off the throttle and look for a safe place to stop off the travelled lane.
- Once stopped safely, shut the engine down when the temperature keeps rising or a stop-engine warning appears.
- If steam or coolant is coming from the engine bay, stay clear of the front of the truck and do not open the hood until it has stopped.
- Leave the radiator and surge tank caps closed. The system is under pressure and the coolant can scald.
- Call with what the gauge did and when, and anything you can see from a safe position. Fire, injury or immediate danger: call 911 first.
What not to do
- Do not open the radiator or surge tank cap on a hot engine. Pressurised coolant can spray out and scald.
- Do not keep driving with the gauge climbing to make the next exit or town.
- Do not pour cold water into a hot engine.
- Do not reach near the fan or belts with the engine running. The fan can engage without warning.
- Do not keep topping up and carrying on without finding where the coolant is going.
- Do not mix coolant types without knowing what is already in the system.
When you call, have ready
- What the temperature gauge read, and when it rose: at idle, on a grade, with a load or at highway speed.
- Any warnings on the dash, and whether the engine derated or shut itself down.
- Where the coolant seems to go: on the ground, sprayed on the engine, out the exhaust as white smoke, or nowhere visible.
- How often the coolant has needed topping up lately, and with what coolant.
- Engine make and model, the load and the outside temperature.
- Any recent cooling-system, belt or engine work.
Not sure exactly where you are?
Your phone can find the spot and write the text for you.
Your text
Uses this phone’s location. Nothing is sent: copy it to paste in a message or read it out when you call.
What we check
Depending on the symptoms, the technician may check:
- Coolant level, condition and type, and signs of oil in the coolant
- A pressure test of the cooling system and the pressure cap, once the engine has cooled
- Upper and lower radiator hoses, bypass and heater hoses, and their clamps
- The radiator and charge air cooler for leaks, damage and fins blocked with chaff, bugs or road dirt
- Fan clutch engagement and the air or electrical signal that controls it
- Thermostats, and whether the engine warms up and holds temperature normally
- The water pump for weeping at the weep hole or bearing play
- Drive belts, the belt tensioner and idler pulleys
- Coolant temperature sensor readings compared with an independent reading
- Signs of coolant in the exhaust or the oil that point at an EGR cooler or head gasket
Common causes
Possibilities, not a diagnosis of your unit:
- A split or swollen hose, or a loose clamp
- A fan clutch that does not engage, or a fault in its control
- A thermostat stuck closed
- A leaking water pump seal or a failing pump bearing
- A radiator leaking or packed with debris on the outside
- A pressure cap that no longer holds pressure
- A broken belt or a failed tensioner
- An EGR cooler leaking coolant into the exhaust
- A head gasket or other internal engine leak
- A faulty temperature sensor giving a false reading
Roadside or shop?
Often done where the unit is
- Hose and clamp replacement, after the engine has cooled
- Belt and tensioner replacement where they can be reached safely
- Fan clutch control faults: the air line, solenoid or wiring
- Refilling, bleeding air out and pressure-testing the system
- Temperature sensor replacement
Often better handled in a shop
- Radiator or charge air cooler replacement
- Water pump replacement that needs major disassembly
- EGR cooler replacement
- Head gasket or other internal engine repairs, or coolant found in the oil
Every fault and every spot is different. Describe it on the call and we will tell you what can be done where the unit is.
How it works
Call, or send your location
Call the location nearest the unit, or text a map pin with the unit number, then call.
Describe the truck, trailer and problem
What you see, hear and smell, the warning lights or codes, and whether the unit is loaded.
We assess it with you
From what you describe, and again when the technician reaches the unit: what is wrong, and whether it can be repaired where it stands.
Repair where the unit is, when it is appropriate
When the fault and the spot allow it to be done safely and properly.
A shop or further work, when it is needed
When it cannot be done on site, we tell you why and what the next step is.
Where we work: Winnipeg, Highway 1 and Brandon
Summer heat, a heavy load and a strong headwind on the Trans-Canada Highway (Highway 1) are when a weak cooling system shows up first. Around Brandon, Headingley and Winnipeg, tell us your direction, the closest crossroad, exit or kilometre marker, and what the gauge did before you stopped.
Roadside assistance and mobile truck and trailer repair 24/7 along the Trans-Canada Highway (Highway 1) between Winnipeg and Brandon, in both directions: Headingley, St. François Xavier, Elie, Oakville, Portage la Prairie, MacGregor, Austin, Sidney, Carberry and Douglas, and the yards and roads around them.
- 646 Pipeline Road, Winnipeg, MB R2P 2T7 (204) 960-5390
- 1601 Moreland Ave, Brandon, MB R7C 1A6 (431) 279-4008
Questions
- Why does my truck overheat on hills?
- A long pull under load is when the cooling system works hardest. A radiator partly blocked on the outside, a fan clutch that slips, a tired water pump or low coolant leave no margin, so the gauge climbs when the demand peaks. It is a warning to have the system checked before it fails outright.
- Why does it overheat at idle but not on the highway?
- Most often the fan is not doing its job. At speed, air is forced through the radiator; stopped or in slow traffic the fan has to pull it through. A fan clutch that will not engage, or a fault in the signal that tells it to, is a common cause.
- Where is my coolant going if I cannot see a leak?
- It may be leaving through the engine instead of onto the ground. An EGR cooler leak can push coolant into the exhaust, a head gasket can let it into the cylinders or the oil, and a heater core can leak inside the cab. A pressure test and a look at the exhaust and oil narrow it down.
- Can I just add water to get going?
- It is better not to, and never into a hot engine. Cold water in a hot engine can crack components, and water alone gives no freeze or corrosion protection in a Manitoba winter. If the truck is stopped somewhere unsafe, call and describe what you see before adding anything.
- Can you fix a burst coolant hose at the roadside?
- Often, yes, once the engine has cooled. Hoses, clamps and many belts can be replaced where the truck stands if it can be worked on safely. The system is then refilled, bled and checked for other leaks.