Emergency and roadside Mobile truck tire service

Blown a truck or trailer tire?

Nexgen comes to trucks and trailers with a blown, flat or damaged tire and replaces it on site when the work can be done safely where the unit has stopped: on a shoulder, a ramp, a yard or a customer lot. We also look at what the failure may have damaged around it. Get the unit off the travelled lane, stop driving on the damaged tire, and call with the tire position and size if you know it.

Can I keep driving on a flat or blown tire?

Only as far as the nearest place you can stop safely, and slowly. A flat steer tire takes away steering control. On a dual, the good tire is now carrying the whole load on that side; it overheats and can fail too, and a flat tire dragging between duals can get hot enough to burn. A tire that is separating or showing cords can come apart and throw tread into fenders, air lines and wiring, or into the vehicle behind. Continuing to operate may risk further damage or create a safety issue, so pull over and call rather than trying to reach the next town.

Drive tire tread and sidewall Example

Example: a drive tire rolling to a stop for inspection; tread depth, the sidewall and the valve are checked before the unit moves again.

Call the nearest location.

Call now (204) 960-5390

Injury, fire or danger: call 911 first. We take calls 24/7.

Problems we commonly inspect

A blowout on the highway
A bang, then a pull, a vibration or a sag on one corner; which position it was decides how urgent the stop is.
A dual running low or flat
Often the inside dual, found at a pre-trip or a fuel stop because its partner kept the unit level.
Tread separating or a bulge in the sidewall
A lump, a wave in the tread or a section lifting away from the casing: the tire is coming apart.
Exposed cords or steel belts
Wire showing through the tread or sidewall means the casing has worn or been cut through.
Smoke or the smell of hot rubber at a dual
A flat tire rubbing against its partner or a fender, or heat coming from the wheel end behind it.
A damaged wheel, studs or nuts
A cracked or bent wheel, rust streaks from a nut, or a missing nut after a tire failure: more than a tire change.

Stop driving, or can it wait?

Stop and get help

  • A steer tire has blown or is losing air.
  • A dual is flat and its partner is carrying the load.
  • Cords are showing, the tread is lifting, or the sidewall bulges.
  • Smoke, flame or a smell of burning rubber from a tire.
  • A wheel wobbles, a nut is missing, or the wheel looks cracked or bent.

May be safe to assess further

  • A tire reads a little low on a gauge at a pre-trip, holds pressure and shows no damage.
  • A small cut in the tread with no cords showing and no air loss.

Continuing to operate may risk further damage or create a safety issue. When in doubt, stop where it is safe and call. Injury, fire or immediate danger: call 911 first.

What to do right now

  1. If a steer tire blows, hold the wheel firmly, ease off the throttle and avoid hard braking until the truck is under control, then steer for the shoulder.
  2. Get as far off the travelled lane as you safely can: a wide shoulder, a ramp or a pull-out is better than stopping beside a live lane. Hazards on.
  3. Put out warning triangles if you carry them and can place them without walking in traffic.
  4. Look at the tire only from the side away from traffic. Do not touch a tire or wheel that ran flat; it can be very hot.
  5. Call with the tire position and what you saw. Smoke or flame at a tire, injury or immediate danger: get clear of the unit and call 911 first.

What not to do

  • Do not change a truck tire yourself, or jack the unit, at the roadside.
  • Do not stand beside the traffic-side tires while you wait; wait somewhere clear of the lane.
  • Do not air up a tire that has run very low or flat: a weakened sidewall can rupture without warning when it is reinflated.
  • Do not drive on to the next town on a flat dual to save a call.
  • Do not touch a tire, wheel or hub after a tire has run flat or smoked.

When you call, have ready

  • Where the unit is stopped: road and direction, the last exit or landmark you passed, or a map pin, and whether it is on a shoulder, a ramp or a lot.
  • The tire position: steer, drive or trailer; which axle; left or right; inside or outside dual, or a wide-base single.
  • The tire size from the sidewall, such as 11R22.5 or 295/75R22.5, if the damaged tire or its partner can be read from a safe spot.
  • Whether the unit is loaded or empty, and what the load is if it is time-sensitive.
  • Any other damage you can see: a fender, mud flap, light, air line or wiring hit by tread.
  • Whether your fleet requires a particular tire, tread type, a purchase order or its own tire account.

Not sure exactly where you are?

Your phone can find the spot and write the text for you.

Your position

Open in Maps

What a pin cannot say

Your text

Uses this phone’s location. Nothing is sent: copy it to paste in a message or read it out when you call.

What we check

Depending on the symptoms, the technician may check:

  • The failed tire, to see why it failed and whether the wheel or anything around it was damaged
  • The partner tire on a dual, for heat damage and a size or tread depth that still matches
  • Size, load range and tread type, so the replacement suits the position on the unit
  • The wheel for cracks, bends and damage at the bead seat and stud holes
  • Wheel studs and nuts for stretching, stripped threads, and loose or missing nuts
  • Valve stems and inside-dual valve extensions
  • Fenders, mud flaps, air lines, lights and ABS sensor wiring hit by tread
  • Pressure in the remaining tires on that axle

Common causes

Possibilities, not a diagnosis of your unit:

  • Running underinflated, often an inside dual nobody could see, until heat broke down the casing
  • Road debris, a pothole or a curb strike
  • Duals that do not match in size, wear or pressure, so one carries more than its share
  • An overloaded or unevenly loaded axle
  • Heat from a dragging brake or a failing wheel bearing
  • A leaking valve stem, or a bead leak at a corroded wheel
  • Uneven wear from alignment or suspension problems

Roadside or shop?

Often done where the unit is

  • Replacing a blown or flat tire on a steer, drive or trailer position where there is safe room to work
  • Fitting the spare the unit carries
  • Replacing a damaged valve stem or valve extension
  • Checking the partner tire and the wheel before the unit moves again

Often better handled in a shop

  • Wheel studs or a hub damaged in the failure, where the hub has to come off
  • Brake, air line or wheel-end damage from a long run on a flat or a tire fire
  • An alignment check after a steer tire failure or uneven wear
  • A traffic-side tire on a narrow shoulder that cannot be worked on safely where it stands

Every fault and every spot is different. Describe it on the call and we will tell you what can be done where the unit is.

How it works

  1. Call, or send your location

    Call the location nearest the unit, or text a map pin with the unit number, then call.

  2. Describe the truck, trailer and problem

    What you see, hear and smell, the warning lights or codes, and whether the unit is loaded.

  3. We assess it with you

    From what you describe, and again when the technician reaches the unit: what is wrong, and whether it can be repaired where it stands.

  4. Repair where the unit is, when it is appropriate

    When the fault and the spot allow it to be done safely and properly.

  5. A shop or further work, when it is needed

    When it cannot be done on site, we tell you why and what the next step is.

Where we work: Winnipeg, Highway 1 and Brandon

A tire that fails on the Trans-Canada Highway (Highway 1) near Brandon, Headingley or Winnipeg: tell us which way you were heading, the last exit you passed, and which side of the unit the tire is on. A tire on the traffic side changes how the job is set up.

Roadside assistance and mobile truck and trailer repair 24/7 along the Trans-Canada Highway (Highway 1) between Winnipeg and Brandon, in both directions: Headingley, St. François Xavier, Elie, Oakville, Portage la Prairie, MacGregor, Austin, Sidney, Carberry and Douglas, and the yards and roads around them.

Questions

Can you change a truck tire on the highway?
Often, when there is safe room to work. A wide shoulder, a ramp or a pull-out usually is fine. A tire on the traffic side of a narrow shoulder may need the unit moved to a safer spot first, and the technician decides that on site and tells you why.
Do you carry my tire size?
Tell us the size when you call and we will tell you what we can do. Steer, drive and trailer positions and wide-base singles all take different tires, so the size and position decide what replacement is needed and whether a matching one is available.
Should both tires on a dual be replaced?
Not always, but the partner tire has to be checked. It carried the whole load while the other was flat and may be heat-damaged, and duals need to match closely in size and wear or one will carry more than the other.
How did my inside dual go flat without me noticing?
Because it is hard to see and its partner held the unit up. An inside dual can run low for a long way without any lean or pull. Checking every tire with a gauge at the pre-trip, through valve extensions where fitted, catches it before it fails.